Working at the router requires a lot of accessories that must always be at hand.
Already if you have a top, always make sure that it has all the basic safety: a housing with a bar guide, a tree with all its rings, hat and screw at the end of the shaft to tighten the tools.
Then, to have fun is to have at your fingertips: grasshoppers, a ruler, a caliper, etc.
If you decide to work on the tree, that is to say, do some fretwork or copying, get the tree work guide, ball guide rings or multi-curved template is almost essential.
And as a router can also work as a router, do not forget that the chuck carbide router bit exists, fits at the end of the shaft and allows for a small molding quickly.
Active filters
Safety guide with a length of 700 mm in aluminum adapted to the small spindle moulders model
Security Guide a length of 700 mm aluminum adapted to the model of a spinning top or average combined model. (also available in length of 600 for smaller models and 1000 mm for the larger rotors).
Safety guide with bars for spindle moulder length 1000 mm
Pliers for mounting 8mm shank router bits on interchangeable shaft wood router
Pliers for mounting router cutters 12 mm shank on wood routers with interchangeable shaft
The "Multicurve" or "Multichantournage" allows you to quickly and very cleanly carry out all your fretwork jigs with a router or router and that with extreme ease!
Spindle moulder protective cover complete with cheeks and presser
Tightening screw length 55 mm of the router shaft in M16 Holzmann FS160L, Jean l'ébéniste MX5108 and Bernardo T500PF
M16 spindle moulder shaft tightening nut for Holzmann FS160L, Jean l'ébéniste MX5108 and Bernardo T500PF
