General description of the Bernardo AD310S planer thicknesser with helical shaft :

• Reduced noise stress (by around 50%) thanks to a standard helical knife planer shaft and up to 20 times longer knife life (thanks to four-times reusable carbide reversible inserts)
• Advantage of reversible carbide inserts: in the event of damage, the individual knives can be replaced or rotated
• Planing tables fold down at the rear of the machine, allowing space-saving installation
• Carbide knives guarantee crack-free planing results and top-quality surfaces for all types of wood
• Simultaneous lifting of the planing tables for maximum ease of use
• Table feed can be deactivated for planing
• Anodized aluminum guide, tilting from 90° to 45°
• Planer table on central column and support for precise planing
• Numerous protective devices: on/off switch with undervoltage coil, CE-compliant shaft protector, limit switch against accidental starting

Technical characteristics of the Bernardo AD310S planer jointer with helical shaft:

jointer

• Cutting width: 310mm
• Table length: 1610 mm
• Table height: 910mm
• Shaft speed: 4300 rpm
• Carbide reversible inserts: 52
• Shaft diameter: 95mm
• Guide: 1110 x 150mm
• Tilting guide: 90° to 45°
• Maximum removal per pass: 3 mm

Planer

• Table length: 750 mm
• Planer width: 310 mm
• Planing height, min/max: 5 - 225 mm
• Removal per pass max: 5 mm
• Feed rate: 6m/min
• Ø suction nozzle: 100 mm
• Continuous power S1 100%: 3.0 kW (2.7 hp)
• Power S6 40%: 3.0 kW (3.8 hp)
• Voltage: 400V
• Dimensions (LxWxH): 1610 x 900 x 1150 mm
• Weight (approx.): 295 kg

standard equipment

• Helical knife planer arbor with 52 reversible carbide inserts
• Replacement carbide reversible inserts (5 pcs)
• push button

Important Probois recommendation for many woodworking machines:

Before starting, always check the inside of your machine, see if the belts are fitted correctly, tighten the bolts, grease the tables, etc... because the various transports cause vibrations.

Always use a 2.5² wire size extension cord

The extension cord must not exceed 10 meters and must not be rolled up

The use of drums, triplets or multi-plugs is PROHIBITED

Provide an electric meter with special machine start fuses of at least 16A

Have a standard electricity meter with neutral and earth

Always work with a chip extractor for your health and for the guarantee of the machine

Always grease cast iron tables with wood glider

Always work with guards in place

Do not work with blunt or dull blades this can damage the mechanism, the feed of the planer, break the belt

The machine does not start? Undoubtedly the shavings ejection casing is badly set up on the planer jointer side, it is a security!